802643
13
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Dryer Troubleshooting
Gas Dryers
1. Remove any damp clothing from the dryer.
2. Set the timer to an Automatic cycle. Set fabric
selector switch to Regular.
3. Remove the top 3 screws holding the control hood
to the rear panel.
4. Start dryer by pushing in timer knob.
5. Using a volt/ohm meter set to AC voltage,
measure the voltage across terminal “T” and
terminal “N” on timer. Refer to
Figure 2
.
6. Meter should read no voltage when the unit is first
started and the dryer is still heating. Continue to
monitor these points until the burner has shut off
(this will take several minutes even with an empty
load). When the burner shuts off, meter should
read 120 Volts and the timer motor should
advance the cycle.
7. If voltage is present, but the timer does not
advance, replace timer.
8. If meter does not read voltage, check the wiring
continuity using ohm scale on meter. UNPLUG
dryer. Remove Red/Black striped wire from
terminal “T” on timer and perform an ohms check
between the timer wire and the cycling thermostat
terminal, where the Red/Black stripe wire attaches
on the cycling thermostat (located on the blower
assembly). If the wire shows continuity, reattach
the wire on terminal “T” of timer. Replace cycling
thermostat and check for proper operation.
Содержание CTSA7AWN
Страница 2: ......
