Alliance Laundry Systems 801504R1, Руководство по установке

Страница: 10 / 78

Installation
801504
8 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Before You Start
Tools
For most installations, the basic tools you will need
are:
Figure 1
Water
Washer needs two standard 3/4 in. (19.1 mm) water
supply faucets with a pressure between 20 and
120 pounds per square inch (138 to 827 kPa). For more
detailed information, refer to section on
Water Supply
Requirements .
Gas
Dryer is equipped for Natural Gas with a 3/8 in. N.P.T.
gas supply connection. For more detailed information,
refer to section on
Gas Requirements .
Location
Place the unit on a solid floor with an adequate air
supply. For more detailed information, refer to section
on
Location Requirements .
Exhaust
Use rigid metal duct and exhaust the dryer to the
outside by the shortest route possible.
NOTE: For more detailed information, refer to
section on
Dryer Exhaust Requirements .
Figure 2
Electrical
●
WASHER
Refer to serial plate for specific electrical
requirements. For more detailed information,
refer to section on
Washer Electrical
Requirements .
●
ELECTRIC DRYER
Dryer needs a 3 or 4 wire 120/240 or 120/208 Volt,
60 Hertz, 30 Amperes, AC single phase electrical
supply. For more detailed information, refer to
section on
Electric Dryer Electrical
Requirements .
●
GAS DRYER
Dryer needs a 120 Volt, 60 Hertz, 15 Amperes,
polarized 3-slot effectively grounded receptacle.
For more detailed information, refer to section on
Gas Dryer Electrical Requirements .
NOTE: 208 Volt heating element is available
(as optional equipment at extra cost).
D814I
1 Wrench
2 Screwdrivers
3 Pliers
4 Socket Wrench
5 Teflon Tape
6 Level
7 Duct Tape
1 2 3
4
5
6
7
SWD442N