Allett UPLIFT86, Руководство оператора и каталог запасных частей

Страница: 18 / 50

18
This mower is fitted with a blade brake clutch. When the blade clutch lever is
disengaged the brake device ensures that the blades rapidly come to a stop. For
safety reasons it is important that the function of this device is checked daily. Check
that the blades start to rotate when the clutch lever is engaged and that they stop
rapidly when it is released. Make adjustments if necessary as outlined in section 7.2
above
7.3 Cable midway adjuster
If the mower does not drive forwards adequately it may be necessary to adjust the
cable as follows using the midway adjuster:

Tools required: 8mm spanner x 1
11mm spanner x 1
1) Slacken lock nut
2) Turn the adjuster a few times clockwise
3) Retighten the adjuster with the lock nut
7.4 Checking the engine oil
Change the engine oil after the first 5 hours of use. The oil should then be changed
every 50 hours or at the end of each season before storage, whichever is sooner.
1) Clean the area around the combined dipstick and filler cap
2) With the mower standing on level ground, unscrew and remove the engine oil filler
dipstick (8)
3) Wipe the oil filler dipstick clean: insert the oil dipstick, SCREW IT IN then remove it
again.
4) Check the oil level
5) Add a good quality
SAE 10W-30 oil in small quantities at a time, allowing it to
settle. Repeatedly add oil and check the level until it reaches the upper limit.
If the blades turn before the clutch drive lever is
operated, move the adjuster UP towards the
handle bar. Making sure the screw head is with
in the ‘brake zone’
Maximum
Minimum
– Add oil
Oil drain plug
– accessed
through a cut out under
engine plate
1 & 3
2
✓