allen HDX750, Руководство по эксплуатации и запасным частям

Страница: 32 / 82

2-4
SECTION 2
OPERATIONS
056335; 01/12
2.2.1 Before Starting Procedures
Before starting the riding trowel check for the following:
1) Oil level in engine.
2) Hydraulic oil level in the reservoir.
3) Fuel level in fuel tank.
4) Condition of riding trowel arms and blades.
5) Verify that daily maintenance of grease points has been performed.
6) Check all hoses and fittings for leaks.
7) Check engine coolant.
2.2.2 Starting Procedures
Before starting riding trowel, refer to Figure 2.2.1 and Figure 2.2.2 for location and
identification of operational and visual controls pertaining to the operation of the riding
trowel.
1) Sit down correctly on the riding trowel seat. DO NOT attempt to start the
riding trowel without an operator in the seat. This machine is equipped with an
automatic shut down system if an operator is not in the seat.
2)
Turn key counter-clockwise until the glow plug light goes off then clockwise until the
engine engages and starts.
To much throttle during start-up will flood the engine.
3)
Turn key to the run position and allow spring back. Allow engine and hydraulics to
warm up before operating trowel.
(See Cold Weather Startup Procedures)
Operating the starter for more than 5 seconds can damage
the starter or engine. If engine fails to start release the switch
and wait 15 seconds before operating starter again.
2.2
Start Up Procedures