allen HDX605, Инструкция по безопасности и эксплуатации

Страница: 38 / 62

4. With the operator in the seat, show him the functions of the joysticks [B] and [C] and how
to start the machine.
A hard level concrete slab with water on the surface is an ideal place for an operator to practice with the
machine. For practice pitch the blades up approximately 1/4 inch on the trailing edge. Start by making
the machine hover in one spot and then practice driving the machine in a straight line and making 180
degree turns. Best control is achieved at full engine RPM.
After starting engine, fully engage the throttle. This allows
the engine to warm up quicker and also engages the torque
converter. At this time the machine’s rotors will begin
turning so long as foot pedal [E] is engaged.
DO NOT use excessive pressure on the joysticks. Excessive
pressure does not increase the reaction time of the machine
and can damage steering controls.
5. Engine Speed
The engine has two primary speed settings: Idle (1200 RPM) & Full (3400 RPM)
The engine will start at idle speed. This machine is equipped with a Cold
Weather Start circuit, meaning that the engine RPM will not increase above
idle speed until the hydraulic oil has reached an optimum temperature. The
operator can activate the RPM toggle to
FULL
during this period, however the
RPM will not increase until that optimum temperature is achieved.
There is a seat sensor on the machine that will not allow the engine RPM to go
above idle speed if the operator is not seated. Therefore, the operator must be
seated AND the Cold Weather Start circuit must be disengaged in order for to
achieve full RPM speed.
6. Cruise Control
This machine comes standard with a cruise control function. The cruise will
allow the operator to remove their foot off the foot pedal and still maintain rotor
function.
To use the cruise control, enable the foot switch so that the rotors engage,
then pull up on the cruise control button. To release the cruise control, press
down on the center button on the cruise control then pull up slightly to disen-
gage.
Trowel Operation
SECTION 2
OPERATIONS
068356 Page 38