8
Publication
1734-IN582B-EN-P - February 2005
Set the Node Address
Set the node address using the 2-position thumbwheel switch. Valid
settings range from 01 to 99. Press the + or - buttons to change the
number.
Install a Replacement ControlNet Adapter to an Existing System
ATTENTION
You must use Series C Point I/O modules with the
1734-ACNR. Series A and B Point I/O modules will
not work with the 1734-ACNR.
WARNING
When you insert or remove the module while
backplane power is on, an electrical arc can occur.
This could cause an explosion in hazardous
location installations.
Be sure that power is removed or the area is
nonhazardous before proceeding. Repeated
electrical arcing causes excessive wear to contacts
on both the module and its mating connector.
Worn contacts may create electrical resistance that
can affect module operation.
Module
Status
PointBus
Status
ControlNet A
Status
1734-ACNR
ControlNet B
Status
Field
Power
System
Power
0
A
B
2
43248
Network Node
Address
thumbwheel
Press either the +
or - buttons to
change the
number.
