3-12
Installing A ControlNet Cable System
Publication 1786-6.2.1 - April 1998
5.
After you have moved the chamber gauge ring to the last position
and turned the strip tool the final time:
A. move the chamber-gauge ring backward to release the
strip tool, and remove it from the cable.
B. strip away the appropriate portion of the cable,
without using the strip tool.
This should appropriately strip the cable, exposing these layers of
the cable:
Important:
If you do not see the three distinct layers of cable, snip
off the exposed end with the wire cutters and repeat
the entire cable-stripping process.
If stripping problems persist, the strip tool may need adjustment.
See appendix B for instructions on how to adjust the strip tool.
If you are using:
Go to:
FEP cable
step 6
PVC cable
step 7
Clean the remaining cable parts from the strip
chamber after each use.
20075
all 4 shield layers—
braid/tape/braid/tape
white insulation
or 1st tape
center
conductor
8.3 mm
3.7 mm
4.0 mm
20076a
