Allen-Bradley armorstratix 5700, Руководство пользователя, Страница: 26 / 458

26 Rockwell Automation Publication 1783-UM007I-EN-P - December 2017
Chapter 2 Get Started
Express Setup Overview When you first install the switch, use Express Setup to perform these initial
setup tasks:
•
Assign the switch an initial IP address. You can then access the switch
through the IP address for more configuration.
•
Run the global macro to set initial configuration parameters as described
on
page 42 .
Express Setup Requirements
Multi-mode and single-mode versions of Express Setup are available depending
on your switch and IOS release:
•
With IOS release
15.2(4)EA3 or later
, all switches use multi-mode
Express Setup as described on page 30 .
•
With IOS release
15.2(4)EA or earlier
, all switches use single-mode
Express Setup as described on page 34 .
Multi-mode Express Setup enables you to configure network settings in either
Device Manager or the Studio 5000 Logix Designer® application. To configure
network settings via the Logix Designer application, you must have the Add-on
Profile (AOP) for Stratix® switches,
version 11.01.xx or later
.
You need this equipment to install the switch.
For 1783-BMS4S2SGL or 1783-BMS4S2SGA switches, you also need a
Gigabit copper SFP module, such as Allen-Bradley catalog number
1783-SFP1GSX, or a Gigabit fiber-to-Ethernet media converter.
Component Requirement
Hardware
Processor 1 GHz or faster 32-bit (x86) or 64-bit (x64)
RAM 1 GB RAM (32-bit) or 2GB RAM (64-bit)
Hard disk space 16 GB (32-bit) or 20 GB (64-bit)
Software
Operating system Windows 7
Web browser Latest version of Internet Explorer™ or Firefox with JavaScript enabled.
Express Setup verifies the browser version when starting a session, and it does
not require a plug-in.
Computer-to-switch connection
(single-mode Express Setup or
multi-mode Express Setup in
Short Press mode) Straight-through or crossover Category 5 Ethernet cable
or
(ArmorStratix™ 5700 switches) M12-to-RJ45 patchcord, such as Allen-Bradley®
catalog number 1585D-M4TBJM-2