Allen-Bradley armorstratix 5700, Руководство пользователя, Страница: 42 / 458

42 Rockwell Automation Publication 1783-UM007I-EN-P - December 2017
Chapter 2 Get Started
6.
Click OK.
The switch initializes its configuration for typical industrial
EtherNet/IP applications by running the global macro as described on
page 42 . You can perform for further configuration or close the
application.
7.
Turn off DC or AC power at the source, disconnect any cables to the
switch, and install the switch in your network.
8.
For Stratix 5400 and Stratix 5410 switches, synchronize the SD card
that came with the switch with the internal memory of the switch as
described on
page 67 .
Default Global Macro Once you complete Express Setup, the switch runs a default global macro
(ab-global). This macro configures the switch for industrial automation
applications that use the EtherNet/IP protocol. This macro sets many
parameters, including these major settings:
•
Enable IGMP snooping and querier
•
Enable CIP
•
Enables alarms, SYSLOG, and SNMP notifications
•
Enables Rapid Spanning Tree (RSTP), BPDU Guard, BPDU Filter, and
loop guard
•
Configure Quality of Service (QoS) settings and classify CIP, PTP, and
other traffic (does not apply to switches with lite firmware revisions)
If you do not run Express Setup to initialize the switch, the global macro does
not run. You can use the CLI, described on
page 70 , to run the global macro.
IMPORTANT For 1783-BMS4S2SGL or 1783-BMS4S2SGA switches, make sure that
DC power is disconnected before disconnecting Ethernet cables.
IMPORTANT The default QoS setting applied by the default global macro assigns the
same priority to traffic for CIP and traffic for Integrated Motion on the
EtherNet/IP network applications. However, you can assign a higher
priority to motion traffic by manually applying optional QoS macros after
you run Express Setup. For more information, see
page 153 .