Allen-Bradley, Rockwell Automation, Rockwell Software, and Guardmaster are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Rock
w
ell Otomasyon Ticaret A
.
Ş
.
, Kar Plaza İş Merkezi E
B
lok Kat:6 34752 İçerenköy, İstanbul, Tel: +90 (2
1
6) 569
8
400
Rockwell Automation maintains current product environmental information on its website at
http://www.rockwellautomation.com/rockwellautomation/about-us/sustainability-ethics/product-environmental-compliance.page
.
Publication 440J-IN001B-EN-P - June 2016
09279 Ver 04
Supersedes Publication 440J-IN001A-EN-P - February 2012
Copyright © 2016 Rockwell Automation, Inc. All rights reserved. Printed in the U.S.A.
Maintenance
Every Week
Chec
k
the correct operation of the switching circuit. Also chec
k
for
signs of abuse or tampering. Inspect the switch casing for damage. Of
particular importance is damage, which causes loss of sealing at the lid
or conduit entry.
At Least Every Six Months
Isolate the power. Remove the lid. Inspect all terminals for tightness.
Clean out any accumulation of fine dirt, and so forth. Chec
k
for any
sign of wear or damage, for example, rubber boot wear or contact
oxidization, and replace if apparent. Replace cover and tighten screws
to specified settings. Reinstate the power and chec
k
for correct
operation. Reapply tamper evident varnish or similar compound to
mountings.
Repair
If there is any malfunction or damage, no attempts at repair are made.
The unit has to be replaced before machine operation is allowed.
DO NOT DISMANTLE THE UNIT.
Precautions for Operation
Do not apply excessive shoc
k
to the switch. Wire the switch correctly
after reading this instruction sheet. To help ensure safety of the control
system, connect each pair of contacts of the three-position switch
(terminal number 1-2 and 3-4) to a discrepancy detection circuit such
as a safety relay module (ISO 13849-1/EN 954-1).
When wiring, prevent dust, water, or oil from entering the grip switch.
Do not tie the grip switch around the button with tape or string to
k
eep the switch in position two. Otherwise, the original function of the
switch is not used, which poses a great ris
k
of danger. If used in wet
locations, this device must be used with cable suitable for wet locations.
EU Declaration of Conformity
The Declaration of Conformity declares that the products that are
shown in this document conform with the relevant requirements of the
Low Voltage Directive (2014/35/EU).
These products also conform to EN 60947-5-1, EN 60947-5-8,
GS-ET-22, UL 508, CSA C22.2 No. 14 and have Third-Party
Approval. Conforming with the European Machinery Directive
depends on the application of the product.
For a comprehensive certificate, visit: www.ab.com/safety.
Additional Resources
These documents contain additional information concerning related products from Rockwell Automation®.
You can view or download publications at
http://www.rockwellautomation.com/global/literature-library/
overview.page
. To order paper copies of technical documentation, contact your local Allen-Bradley distributor or
Rockwell Automation sales representative.
Resource
Description
Industrial Automation Wiring and Grounding Guidelines,
publication
1770-4.1
Provides general guidelines for installing a
Rockwell Automation industrial system.
Product Certifications website,
http://www.rockwellautomation.com/global/certification
/overview.page
Provides declarations of conformity,
certificates, and other certification details.
