ALLEN
&
HEATH
6
XONE:96 Guide:
Replacing Faders
REPLACING CHANNEL FADERS
Step 6:
To replace Channel Faders
•
Remove the cross-fader assembly prior to replacing channel fader/s, as described in Step 4 above.
•
Remove and retain 2 screws securing the channel fader PCBA.
•
Slide the Channel Fader PCBA away from its connection to the main top panel PCBA as shown.
•
Take the cap off the Channel Fader shaft to remove the assembly clear from the top panel.
To replace Channel 1-4 faders, order A&H spare part-code:
004-999X
-
XONE:96.CH.FADER
•
The new replacement Channel Fader assembly is a push-fit onto the main top panel PCBA.
•
Ensure the pins on the main top panel PCBA are aligned correctly with Channel Fader PCBA connector.
•
Replace the Channel Fader knob and screw the Channel Fader back to the top panel.
•
Fit the new XFADER and spacer PCB to the top panel and replace the XFADER knob.
•
Repeat Step 6 as necessary for each fader that needs to be replaced.
•
Screw the XFADER assembly back to the top panel.
•
Re-connect the black wire-form from connecting XFADER to the top panel PCBA.
•
Reassembly of the mixer is the reverse of Steps 1 - 3, detailed above.
•
NOTE
: When re-assembling the mixer, take great care to refit harnesses in correct positions and to ensure
connectors are fully fitted into the corresponding socket.
