4
WZ
3
12MON
SYS-LINK Option Fitting Instructions AP7007
Step 9:
Connect the SYS-LINK power
Both option cards get their power from the
c15V and -15V rails available at solder
pads on the rear connector PCB.
Solder the SYS-LINK card sleeved red and
black wires to the connector card: red to (+15),
black to (-15), green to ground 0V. Check that
the solder joints are of good quality.
GREEN
=
GROUND
BLACK
=
-15V
RED
=
+15V
Step 10:
Refit the clamp bracket
The clamp bracket securing nuts
should be tightened just enough to prevent
excessive movement of the IDC harnesses.
Do not overtighten as this may cause
damage to the harnesses.
Refit the clamp bracket using the five M3 nuts.
The positions of the IDC harnesses may need
adjusting to allow enough slack on either side
when the clamp is tightened.
Step 11:
Refit the connector panel
Check your work carefully and ensure that there
is no dirt or debris inside the connector pod.
Ensure that all IDC harnesses are correctly
inserted and positioned.
Carefully refit the connector panel to the
console. Replace the ten M3x6 Pozi screws - six
at the rear of the connector panel and two at
each side.
Step 12:
Refit the base
Check that all harnesses are correctly inserted
and positioned, then carefully replace the base
panel and refit the four underside base M3x6
Pozi screws. Rotate the connector pod and refit
the three M3x6 Torx rear base fixing screws.
Rotate the pod again and secure it in place with
the two M4x8 flange Pozi screws. Refit the side
trims if required using the one M4x10 and three
M4x8 Pozi screws per side.
Step 12:
Apply the panel label
With all panels refitted, stick on the adhesive
label AN7066 supplied with the kit. This
identifies the top connector as SYS-LINK OUT
and the lower connector as SYS-LINK IN.
Step 13:
Test
With all panels refitted, connect to the mains
supply. Power on and check for correct
operation.
Step 14:
The cable
A 37way male to male D-type cable is required
to interconnect two consoles fitted with the SYS-
LINK option. Use 36-core shielded cable with
the 36 connections wired one to one and the
screen soldered to pin 19. Maximum
recommended length is 10 metres.
REFIT WITH 5x M3 NUTS - DO NOT OVERTIGHTEN
USER OPTION PORT A
L
R
L
R
MONITOR
EXT MONITOR IN
USER OPTION PORT B
OUT
SYS-LINK
IN
SYS-LINK
OUT
A suitable cable is
available from Allen &
Heath:
Part AH4131
37way 2.8 meters
