WZ
3
12MON
SYS-LINK Option Fitting Instructions AP7007
1
These are the instructions for fitting the SYS-LINK Version 2 console expander option to the
MixWizard
WZ
3
12MON
consoles. Two consoles, each with SYS-LINK V2 installed, may be linked together using a
single 37 way cable such that one becomes a channel expander (slave) to the other (master) providing a
total of 32 channels. This links all the mix buses and the PFL/AFL system. The cable is not supplied but
may be ordered separately or sourced elsewhere. Fitting the option requires removal of the rear connector
cover to access the internal assemblies, installation of a circuit card assembly and ribbon harness, and
some soldering. This work should be carried out by technically competent personnel.
For information on how to use SYS-LINK please refer to the Applications Note AP7008. Should further
assistance be required please contact Allen & Heath Technical Support.
Before Starting
Please see MOD information on last page then read these fitting instructions carefully before starting. For
trouble free installation and operation heed all the precautions noted. The console must be fully
unplugged and removed from its rack, plinth or other furniture before carrying out the work. Normal
workshop tools are required. These include Pozi (crosshead) and Torx (starhead) screwdrivers, and a fine
tipped soldering iron. Provide a suitably large, well lit work surface such as a service workshop bench. To
avoid damage to the cosmetics of the console ensure that the work surface is clean and clear of
obstructions. Allow enough time to carry out the work properly and test the results.
Check the Contents
003-727-A x1 SYS-LINK IN circuit assembly
with power harness and fixing nuts.
003-727-B x1 SYS-LINK OUT circuit
assembly with power harness and fixing nuts.
003-727-C X1 SYS-LINK IN SLAVE circuit
assembly.
AL6098 x1 short IDC ribbon harness
AL7005 x1 long IDC ribbon harness
AH0014
WIRE 7/0.2 PVC VIOLET
AP7008 x1 SYS-LINK V2 Applications Note.
IMPORTANT
:
Any changes or modifications
to the equipment not approved by Allen & Heath
could void the compliance of the equipment.
Whilst we believe the information in these
instructions to be reliable we do not assume
responsibility for inaccuracies. We also reserve
the right to make changes in the interest of
further product development.
Copyright© 2007 Allen & Heath Limited. All rights
reserved. www.allen-heath.com
This work should be carried out by
competent technical personnel only.
Disconnect the mains power cord before
opening the unit.
Take care not to damage the panels or
internal assemblies during fitting. Prevent
loose parts or dirt from entering the console
as this may cause equipment failure.
Fitting the SYS-LINK option cards
AP7007 issue 2
Fitting Instructions for the W3MON-SLV2 Kit
SYS-LINK IN
IT IS RECOMMENDED THAT THIS OPTION IS FITTED BY AN APPROVED ALLEN & HEATH SERVICE AGENT
SYS-LINK OUT
