iLive Reference Guide – Hardware
Part 1 - 34
AP6526-1 iss.5
Patching signals to MixRack Port B
iLive recognises the type of option card fitted to Port B of the
MixRack. Use the TouchScreen or Editor
OUTPUTS
screen Port B
tab. You can assign one or a range of signals to the different
outputs by touching the output you want to assign and choosing
selections from the drop down menu. Touch Apply to confirm the
selection.
The input and output patching including Port B is archived within the
Show memories and can be stored in the Scenes ‘Patchbay’ item.
Patching signals to Surface Port B
Port B
at the iLive Surface can be used to provide outputs for
recording
and further signal distribution.
This applies only to the modular iLive Surfaces with the
RAB2
module fitted. The T and R Series Surfaces do not include Port B.
Port A
is used to link local audio at the Surface to and from the
MixRack. It carries 64 signals in both directions. Link channels 1-32
and 63/64 are reserved for the local audio card slots and PAFL
monitor, while link channels 33-62 are available for further signal
distribution from
Port B
at the Surface, for example recording.
Surface Port B and firmware version V1.7
.
It is
possible to fit the
M-MMO
option and assign its outputs, but note
the following:
The
Status
screen does not recognise the Port B option even if one
is fitted.
Use the TouchScreen or Editor
OUTPUTS
screen ACE Link or ESA
tab to assign signals to the
M-MMO
option fitted in Port B. Use
CH33 and higher. These are permanently mapped to the
M-MMO
output sockets according to the table below.
You can assign one or a range of signals to the different outputs by
touching the output you want to assign and choosing selections
from the drop down menu. Touch Apply to confirm the selection.
1 = 33
2 = 34
3 = 35
4 = 36
5 = 37
6 = 38
7 = 39
8 = 40
9 = 41
10 = 42
11 = 43
12 = 44
13 = 45
14 = 46
15 = 47
16 = 48
17 = 49
18 = 50
19 = 51
20 = 52
21 = 53
22 = 54
23 = 55
24 = 56
1 = 57
2 = 58
3 = 59
4 = 60
5 = 61
6 = 62
7 = PAFL L
8 = PAFL R
M-MMO in Surface Port B
Default assignment for firmware
V1.7
Not used
Not used
ADAT
ADAT
ADAT
iDR A
iDR B
AVIOM
Note
For firmware
V1.7
the
M-
MMO
card is the only option
supported in the iLive Surface RAB2
module Port B.
