DX164-W User Guide
AP11446 Issue 2
Floor mounting
The DX164-W can be installed in a floor box / stage pocket /
dip trap. We recommend using the
ACE Backstage 174SLBK
stage pocket
system for use with the DX164-W.
Other options
The DX164-W can
fit a 12x12” NEMA Type 1 box or equivalent.
A custom mounting frame is required.
Permanent installation with the gland module
⚠
Replacement of the IEC module and mains wiring for
permanent installation must be performed by a qualified
electrician. See instructions later in this guide.
To replace the IEC module:
•
Remove the 4 screws using a Torx T8 driver.
•
Pull out the module and unplug the harness at the bottom.
•
Fit the cable gland to the gland module.
•
Run the mains cable through the gland.
•
Wire the mains to the screw terminal, paying attention to polarity and
earth as indicated on the module.
•
Plug the harness into the bottom of the gland module.
•
Secure the module to the unit with the 4x T8 screws.
Screw terminal
for mains
connection
Harness for
internal
connection
