DT22 Getting Started Guide
AP12433 _1
Front panel
Inputs
Balanced Phoenix mic/line inputs.
Output
Balanced Phoenix line outputs.
Gain
Rotary controls for the preamp analogue gain, 0dB to 55dB. Use a Philips screwdriver to adjust
the gain.
PP
+48V Phantom Power and
Mic/Line
switches for Input 1 and 2.
Rear panel
Dante
EtherCon port for connection to the Dante network and Link / Activity LED indicator. Use a PoE
Ethernet switch or PoE injector to power the unit via this port.
Power
LED indicator and
Ready
indicator.
Ready
lights up when the unit is successfully booted and
ready to pass audio.
Factory Reset
Hold down the recessed switch while powering up. After at least 10 seconds,
remove power then power up again normally to reset the network settings and name. This will delete any
static IP address and revert to factory default (DHCP / zero-conf).
DC input
DC 12V connector.
