DT164-W User Guide
AP11870 Issue 1
Top panel and power options
Dante Secondary
Can be set to Redundant mode or to Switched
mode for connection to multiple devices, for example two mixing consoles. Set
the port mode in Dante Controller.
Dante Primary
EtherCon port for connection to the Dante network. The
cable carries the audio signals as well as preamp control data.
Reset Network settings
Hold down the recessed switch for 10
seconds to reset the network settings for the DT164-W. This will delete any
static IP address and revert to factory default (DHCP / zero-conf).
DC 12V Input
Can be used instead of AC mains to power the unit
where adequate DC distribution is provided in a building. Can also be used as
a backup power supply in case of mains failure.
Mains power input
The built-in universal PSU accepts voltages from
100 to 240V AC 50/60Hz. A module with IEC inlet is fitted by default. An
optional module is provided for permanent installation, with knockout holes to
accept a cable gland.
⚠
Replacement of the IEC AC inlet module and mains
wiring for permanent installation must be performed by a
qualified electrician. See instructions later in this guide.
