AHM-16/32 Getting Started Guide
12
AP12764 Issue 1
Set the Audio Sync options so that one device is the clock leader (set to
‘Internal’)
and the other device is a clock follower (sync from SLink or I/O Port as appropriate).
The SLink port does not tunnel control network data. Use the Network port to
connect multiple AHM processors or other Allen & Heath mixers for control
purposes, for example for Embedded Scene Recalls or System Manager operation.
Avantis
dLive (gigaACE card)
SQ
AHM-64
SLink
gigaACE
SLink
SLink
6.4
Dante expanders with Dante card fitted
Control of the DT168 or DT164-W expanders requires an M-SQ-DANT32 or M-SQ-DANT64 (SQ Dante V2)
card fitted in the I/O Port.
Use Dante Controller to patch signals between Dante devices. When a valid DT168 or DT164-W socket is
routed to the AHM processor, and patched to an Input channel, System Manager will present preamp gain,
+48V and Pad controls for the socket.
DT expanders should always be clock followers on the Dante network, with the AHM-64 processor typically
set to
‘Preferred
Leader
’
and
‘Enable Sync to External’
.
Refer to the DT expander Getting Started Guide at
information.
Network Switch
Dante Controller
DT164-W
Dante Clocking:
Slave
DT164-W
Dante Clocking:
Slave
DT164-W
Dante Clocking:
Slave
DT164-W
Dante Clocking:
Slave