75.0022.01 ALLEGION 8310-816 TOUCHLESS ACTUATORS 20200612
Page 5 of 8
Sensor erratically
detecting or falsely
activating
Not properly grounded
Verify continuity between sensor ground and
earth ground.
See Application Note for details.
Unstable power supply
Ensure the isolation module (polarity-sensitive)
is being used with each 8310-816.
Electrical noise within
sensing zone
Reduce sensing zone (potentiometer
counterclockwise).
Non-stationary object
within detection zone
Clear a 10” zone around detection field.
Sensor not detecting
Sensing zone is set
too low
Increase sensing zone (potentiometer
clockwise).
No power
Verify power supply and connection.
TROUBLESHOOTING
The sensor manufacturer cannot be held responsible for incorrect installations or inappropriate adjustments of the sensor/device; therefore, the sensor
manufacturer does not guarantee any use of the sensor outside of its intended purpose.
The sensor manufacturer strongly recommends that installation and service technicians be AAADM-certifi ed for pedestrian doors, IDA-certifi ed for
doors/gates, and factory-trained for the type of door/gate system.
Installers and service personnel are responsible for executing a risk assessment following each installation/service performed, ensuring that the sensor
system installation is compliant with local, national, and international regulations, codes, and standards.
Once installation or service work is complete, a safety inspection of the door/gate shall be performed per the door/gate manufacturer recommendations
and/or per AAADM/ANSI/DASMA guidelines (where applicable) for best industry practices. Safety inspections must be performed during each service
call – examples of these safety inspections can be found on an AAADM safety information label (e.g. ANSI/DASMA 102, ANSI/DASMA 107).
Verify that all appropriate industry signage and warning labels are in place.
INSTALLATION/SERVICE COMPLIANCE EXPECTATIONS
