www.allavino.com
5
1-800-710-9939
Installation Instructions
BEFORE USE:
Remove the exterior and interior packaging.
Before connecting the unit to the power source, let it stand upright for approximately 8 hours. This will reduce
the possibility of a malfunction in the cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
This appliance is designed for both freestanding and built-in use.
Place the unit on a flat, solid floor that is strong enough to support it when it is fully loaded. To level the
appliance, adjust the front leveling leg at the bottom of the unit.
When moving your wine and beverage center, please do not incline it more than 45 degrees.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause it to perform improperly. The optimal ambient temperature range is 65°F - 80°F .
Avoid locating the unit in damp areas.
Plug the appliance into an exclusive, properly installed and grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or electrical grounding should be directed to a certified electrician or authorized products service center.
After plugging the appliance into a wall outlet, allow the unit to cool down for 3 to 4 hours before placing wine
bottles or beverage cans in the appliance.
Note: In a built-in application, the door should protrude at least 1" beyond the surrounding cabinets.
Operation Instructions
The wine and beverage center should be placed in an area where the ambient temperature range is between 65-80
degrees Fahrenheit. If the ambient temperature is above or below this range, the performance of the unit may be
affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate.
When the unit is plugged both indicators will light for 3 seconds, and an audible beep will be heard. The temperatures in
left zone and right zone can be independently controlled and displayed. The temperature display will flash 5 seconds
after the temperature been set, and indicates the current temperature.
Your Allavino Wine and Beverage Center includes an operating panel on the front of the unit. The operating panel
includes several features to operate and control the temperature of the wine and beverage center, including:
ON/OFF Switch - Press and hold
for 3 seconds to turn on/off the appliance
Temp Set - Adjusts and displays the desired temperature on an LED display for each temperature zone
Light - Turns the interior light on or off
°F / °C - Toggles the temperature display between Fahrenheit and Celsius
UNLOCK - If no button has been touched for over 12 seconds, the control panel will get locked automatically. Then NO
button will respond to your touching. Press and hold both the up and down arrows on the wine chiller control panel
simultaneously for 3 seconds to unlock the control panel before you try to change the setting or turn on light.
If you are going on vacation, you may leave the wine and beverage center operating during vacations of less than three
weeks. If the appliance will not be used for several months, you should remove all items and turn off the appliance.
Clean and dry the interior thoroughly. To prevent mold growth, leave the door open slightly, blocking it open if
necessary.
