Alisun Sun lounge Salsa 10, Техническое руководство

Страница: 5 / 14

ENGLISH
ASSEMBLY
1.
Fasten the gas absorber (A) to the
stand (B) by means of the plastic
washer (C) and the locking spring (D).
NOTE: The locking spring should be
pushed in properly, as far as it will go. Once
fitted, a locking spring should not be
removed. A locking spring can only be used
once.
Grasp the canopy on either side of the
centre, then lift it upwards.
2.
Now tilt the equipment such that its
front surface is on the floor.
Fasten the swivel casters (A) to the
bottom of the stand (B).
Now replace the canopy (C) on the
stand.
Remove the protective plastic from the
acrylic sheet.
Check if the voltage rating of your
facilities corresponds with the rating on
the type label.Then insert the plug of
the power cord into a grounded wall
socket.
Your unit is now ready for use.
USAGE
Wheel the equipment (A) (in a vertical
position), to the foot of the bed or place
it in front of a chair. See to it that the
equipment is always located on a flat
surface.
NOTE: the slots of the wheeled base (B)
(incorporating ballast) must not become
covered by any foreign objects.
Grasp the canopy on either side and
pull it towards you.
OPERATION
You can set the timer to the required
number of minutes by turning it clockwise.
After the time has expired the timer will
switch off automatically. If you want to
switch off your unit sooner, the timer should
be turned anti-clockwise to the zero
position.