12
5
KEY OPERATIONS
Frequency Scan
MEMORY Scan(channel scan)
CTCSS/DCS Encode and Decode setup
Scans all VFO frequencies in regard to the preset tuning step.
Scans all memory channels unless Memory skip feature is selected for a
given memory.
1.
In memory mode, press and hold
key for over 2 seconds to
enter into channel scan.
2.
Press Microphone [
/
] key
to change scan direction.
3.
Press any key except
PWR
and
FUNC
key to
exit.
1.
In VFO mode, press
until starts
scanning.
2.
Press Microphone [
/
] key to change scan direction.
3.
Press any key except
PWR
and
FUNC
key to stop.
squelch off(Monitor function:)
Squelch Off: Press
key to disable squelch, press
key again
to resume squelch. While monitoring, all signaling features are
temporary released.
Many repeaters require CTCSS or DCS
tone encoding to access the system. Tone
decoding features are often used to filter
unwanted signals. In this mode, regardless
of the main squelch status, the audio can
be heard ONLY when the matching tone/
code signal is received. The combination
of CTCSS squelch and DCS function is not
available; only one or the other may be used
for a given channel. Tone settings can be
programmed in memory channels. In memory mode, the setting may
be changed temporary but changing a channel or turning off the radio
will cancel the operation and returns to programmed setting.
1.
Press
P3
key. The current setting will be displayed with
T/SQ/DCS
icons and relative frequency/code.
2.
Select icon to set the encoding tone.The number below
represents the tone frequency in Hz. Use [
/
] keys
to select the desired encoding tone.If the repeater requires only
encoding tone, press [PTT] to set and operate.
3.
To set tone squelch, Press
P3
key again to display
icon.
Select decoding tone frequency that can be set different from
encoding tone. Press [PTT] to set and operate tone-squelch.
4.
Press it again so that the 3-digit number and
icon is displayed.
This is the DCS code, and it enables DCS encoding and decoding.
Press [
/
] keys to change codes. Press any key ( Except
FUNC / PWR / TS / DCS
,
UP / DOWN
keys) to enter the setting and
return to original status. The
T/SQ/DCS
icon will remain on the display to
show the current selective-calling status. To exit, simply use the
P3
key
and press it until the relative status icon
T/TQ/DCS
disappears.
