Alinco DJ296, Инструкция по эксплуатации, Страница: 14 / 21

6 digits are displayed, and nothing appears at first.
2. Select the dialer memory NO. with the dial.
3. For example, when you input 1 2 3 4 5 6 7 8 9, the LCD displays as shown below:
[ 1] - [ 1 2] - [ 1 2 3 ] -
[ 1 2 3 4 ] - [ 1 2 3 4 5 6 ] - [ 2 3 4 5 6 7 ] - [ 3 4 5 6 7 8 ] - [ 4 5 6 7 8 9 ]
4. Press and hold the F key, then press 0 key while F icon is ON, pause can be set
instead of the code. Pause is indicated by [ - ]. Entering a pause puts a gap
between transmission of codes.
Press and hold the F key, then rotate the dial while F icon is ON, and the display
scrolls within the range in which the codes are programmed.
5. If you enter the wrong code, press and hold the F key, then press C/CALL(SKIP) to clear.
6. Press the PTT key to complete the setting.
. The auto dialer can be programmed up to 16 digits including the pause.
6-7 Auto Dialer Function
This function automatically sends pre-programmed DTMF codes.
Operation in receiving mode
1. In receiving mode press D/A dial key, [DIAL] appears on the LCD and a
confirmation tone sounds.
Press a key of 1-9, the dialer memory that is accordant with the key No. (max. 16
digits) will be output from the speaker automatically.
. In this case the code is not sent.
If nothing is stored in the memory, a beep tone sounds indicating that the operation
is invalid when you press a key of 1-9.
Operation in transmitting mode
1. Press F key in the transmitting mode. [DIAL] appears on the LCD.
2. Press a key of 19, the dialer memory that is accordant with the key No. (max. 16
digits) will be transmit automatically.
. In this case, a beep tone does not sound if you press the unprogrammed key.
6-8 Redial
This function transmits the last transmitted DTMF codes again.
1. Press D key in receiving mode. A reception tone will sound.
2. Press 0 key. If the code to be redialed is not stored, a beep tone sounds indicating
the operation is invalid when 0 key is pressed.
The last transmitted DTMF codes (either of auto dialer codes or manually
transmitted DTMF code) will be output automatically from the speaker. In this
case the codes are not sent.
Press and hold the F key, then press 0 key in transmitting mode, and redialing
becomes available. In this case the code is sent.
6-9 DTMF Time Setting
This function changes the settings of the wait time of auto dialer, burst/pause time
and burst time of the first digit.
. The settings can be changed in the set mode.
DTMF WAIT time
When the DTMF code is transmitted using the auto dialer, the code transmission
starts after the programmed WAIT time elapsed. The initial setting is 100ms.
DTMF burst/Pause time