Alinco DJ296, Инструкция по эксплуатации, Страница: 10 / 21

(1) VFO SCAN
1. Press the V/M key to enter VFO mode.
2. Press the SCAN key to start scanning.
The decimal point of the frequency on the LCD starts flashing to indicate the
scanning is started.
The unit scans by a channel step to the last direction of operation.
3. Rotate the dial clockwise to scan upward and counterclockwise to scan downward.
VFO SCAN covers all receiving frequency range for scanning.
4. Press any key (except for MONI key) to stop scanning.
(2) Memory Scan
1. Press the V/M key to enter the memory mode.
2. Press the SCAN key to start memory scanning.
3. Rotate the dial clockwise to scan upward and counterclockwise to scan downward.
The memory scan scans only programmed channels.
4. Press any key (except for MONI key) to stop scanning.
The scanning pauses at the channel or frequency where a signal is picked up, then
resumes when the signal is dropped.
(3) Skip Channel Setting
The memory channel that is programmed in the skip channel will be skipped when
the memory scanning.
In the memory mode press and hold the function key, then press C/SKIP while [F]
icon is ON, the selecting memory channel is programmed to the skip channel.
The skip channel is determined at this point without memory programming.
The skip channel is released with the same operation.
. The 10MHz decimal point of the memory channel will appear when the skip
channel is programmed to the channel.
5-11 Output Power Switching
The output power can be switched.
Press and hold the F key, then press 5/H/L key while [F] icon is ON. Output power
can be switched between High and Low.
When the power is LOW, "LO" will appear. Nothing is displayed when the power is High.
The initial setting is LOW power.
RF meter shows 3 dots in LOW power, and 6 dots in HIGH power.
. H/L power switching can not be done while transmitting.
5-12 Key Lock Function
Press and hold the F key, then press B/KL key to set the key lock.
. In key lock mode only PTT, LAMP, MONI, VOL, SQL and TONE BURST/MONI
keys are activate.
. In the key lock mode [ KEY mark] appears.
Press and hold the F key, then press B/KL key while [F] icon is ON to release the key lock mode.
5-13 Tone Burst Function
This is the required function to access the European repeater.
. Press and hold the PTT key then press the MONI key, the tone burst signal will be transmitted.
The initial value of the tone frequency is 1750Hz, and it is changeable in the set mode.