15
BASIC OPERATIONS
Delete Channel
To delete a stored channel follow the below steps.
1. Under standby state, press
key, the top corner of LCD displays " " icon, press
key to switch
into channel mode, channel number flashes.
2. Press
/
to select desired deleting channel number.
3. Press
key, the top corner of LCD displays " " icon, press and hold
key until a beep sounds,
and clear up frequency information of current channel, deletion is successful.
Programmed Scanning
This is a type of VFO scan, and scans only the designated frequency range set into the L1/U1 and L2/U2
channel pairs in the memory mode. This feature is referred to as also “Search” and 2 pairs available. Both
channel pairs can be set freely in the VHF and UHF bands, but the pair channels must be within the same
band. Follow the memory edit instruction to store the lower and upper frequency settings in the L(lower)
and U(upper) pair channels. To scan, in the VFO mode, select a frequency within the scanning range.
Press "
" key. LCD displays " " icon on the upper right corner. Press "
" key to start scanning.
When starts scanning from the off-range frequency, it scans whole receiving range like a normal VFO scan.
2. Press
/
to select desired editing channel number.
3. Press
key, the top corner of LCD displays " " icon, press and hold
key until a beep sounds,
and channel is stored successfully. Repeat the same to overwrite the channel with different data, but
overwrite protection is not available.
