Alienware m17 P37E, Руководство по обслуживанию

Страница: 65 / 111

Removing the display assembly
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in Before working inside your computer . After working inside your computer, follow the instructions
in After working inside your computer . For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance .
Prerequisites
1 Remove the base cover .
2 Remove the wireless card .
Procedure
1 Remove the two screws (M2x3) that secure the power-adapter port bracket to the palm-rest assembly.
2 Lift the power-adapter port bracket off the palm-rest assembly.
3 Lift the power-adapter port off the palm-rest assembly, moving it away from the display hinge.
4 Peel the tape that secures the camera cable to the system board and disconnect the camera cable.
5 Peel the tape that secures the display-cable connector latch to the system board.
6 Open the latch and disconnect the display cable from the system board.
7 Open the display at an angle of 90 degrees and place the computer at the edge of the table.
8 Remove the two screws (M2.5x4.5) that secures the display hinges to the palm-rest assembly.
65