Alienware Area-51 m5750 Technical Reference
0
5. If you need to remove an old DIMM from the socket, press out on the latches
located on both edges of the socket at the same time. The DIMM should pop
up to an angle of 30 degrees (see diagram below). Pull the DIMM module out
of the memory socket. Store away the DIMM for future use.
6. Install the new DIMM module into the memory socket. The DIMM will only fit in
one orientation. Insert the DIMM at an angle of approximately 30 degrees into
the empty memory socket. Then press it firmly so that the contact edge is
driven into the receiving socket.
7. Pivot the DIMM until the latches on both sides of the socket snap into place.
Note: Notice the notch on the DIMM. The notches should fit nicely with the socket.
8. Put the System Device Cover back and tighten 9 Screw D’s.
Congratulations! You have just completed the memory upgrade. When you boot up the
computer, you should expect to see an increase in DRAM capacity.
Note: Your computer has been tested with a wide range of DIMM on the market. However,
not all memory modules are compatible. Check with your system vendor for a list of
compatible DIMM for your computer.
Содержание Area-51 m5750
Страница 29: ...Alienware Area 51 m5750 Technical Reference 29 The following is a quick guide to the keys functions...
Страница 76: ...Alienware Area 51 m5750 Technical Reference 76 APPENDIX A PRODUCT SPECIFICATIONS...
Страница 82: ...Alienware Area 51 m5750 Technical Reference 82 APPENDIX B AGENCY REGULATORY NOTICES...
