Do not pull to tightly on the eye wire when you tuck them into the groove in the
trigger frame as this can pull the wires down inside the eye covers and misalign
the eyes. This is also why you have
aligned the trigger frame about a half and
inch forward in relationship to the gun body,
While looking at both side of the gun, and pulling the solenoid wires and the eye
wires into the trigger frame slide the two half’s together. The two fit snugly
without force. Once you are satisfied that that the eye wire is not being pulled
between the eye covers and the trigger frame’s wire guide groove, that all excess
eye wire between the guide and the frame is pulled into the trigger frame and the
excess wire to the solenoid is pulled into the frame – double checking to see that
the solenoid wire is not sandwiched between the to gun half’s - screw the gun
together with the two screws, one under the trigger guard and one at the back of
the gun under the ram.
DO NOT OVER TIGHTEN.
Connect the wire leads to the board and screw the grip panel on.
16
