1
www.observint.com
ALI-TS2025R_CQ
170706
Base plate
What’s in the box
•
Camera assembly
•
Mounting hardware
•
Video test adapter cable
•
Drill template
•
This instruction guide
Tools you need
To install the camera, you will need:
•
12 Vdc or 24 Vac power source. See
Specifications
for requirements.
•
Tools and additional fasteners (may be required) for mounting the camera
•
Video and power extension cable
Step 1. Install the camera
The camera includes hardware to install it directly to a mounting surface. You can also easily install the
camera onto a single- or double-gang electrical box. Camera drop cables can be routed through the
conduit port on the side of the camera back box, through the mounting surface or into an electrical box, if
used.
Before installation:
•
Make sure that the device is in good condition and all the assembly parts are included.
•
IR Reflection Prevention
: Avoid mounting the camera near reflective surfaces. The IR light from
the camera can reflect back into the lens. Do not remove the plastic cover until the cover is installation
is complete.
•
Check the specification of the products for the installation environment.
•
Make sure that the wall or the ceiling is strong enough to withstand 3 times the weight of the camera.
•
To avoid fire or shock hazard, use only UL listed power supplies. Verify that the power supply will
provide the rated voltage and wattage for the camera. See the
Specifications
section.
During installation:
•
Monitor impedance
: You can attach the video test cable to a CVBS setup monitor. Ensure that the
monitor input impedance is set to 75 Ω.
•
Camera drop cable
: The camera drop cable includes three connectors:
—
Video BNC connector
: Provides the HD-TVI video signal for transmission across a coax (75 Ω)
extension cable.
—
Power connector
: The camera can be powered 12 Vdc or 24 Vac voltage. When connecting
power to the drop cable, observe the polarity marked on the terminals.
The following procedure outlines an installation of the camera to a ceiling. Your installation steps may
differ, depending on how the camera is mounted and how the drop cable connects to video and power
extension cables. The camera can also be mounted to a wall. To install the camera onto a surface:
ALI-TS2025R 5MP HD-TVI
Dome Camera Quick Installation Guide
The ALIBI ALI-TS2025R dome camera include a high resolution CMOS array sensor with and advanced
circuit design technology. The camera features high resolution, low image distortion and low noise features
which makes them suitable for surveillance and image processing systems. Features include:
•
5 MP high performance CMOS array with resolution up to 2560 (H) × 1944 (V) pixels
•
Low illumination: Color: 0.008 Lux @ (F1.2, AGC ON), 0 Lux with IR
•
2.8 mm
~
12 mm motorized lens
•
OSD menu up-the-coax
•
100 ft Full Frame SMART IR
•
IP65 rated weatherproof
•
Requires 5 MP HD-TVI compatible recorder (HD-TVI DVR)
•
Optional installation with wall mount bracket ALI-AB2 and flange adapter ALI-AF3
Camera
back
box
Lens
Camera
dome
assembly
Back Box internal features
Power
Connector
Terminal polarity
indicators
HD-TVI video
BNC connector
Camera drop cable connectors
OSD
joystick
Back
box
Base
plate
IR LED
(2)
Gimbal
pivot
point
Lens
CVBS
video
test port
NOTE
: The black liner
surrounding the
gimbal is not shown
here
Camera module internal features
