ALI Champion CH-44, Руководство по установке и эксплуатации с перечнем запасных частей для сервисного обслуживания

Страница: 23 / 104

15
Installation
Check List
1. Remove white protective film from the dishwasher exterior.
2. Install lower panels to the dishwasher.
3. Remove any foreign material from inside of the machine.
4. Check dishwasher drain/overflows are closed and in securely seated.
5. Install scrap screens, spray arms.
6. Turn main utilities to the dishwasher ON. (Power, water).
7. Make sure doors are closed.
8. Turn dishwasher power switch ON. Machine fills with water and tank heat
comes on.
9. Check tank water temperatures reach proper levels.
10. Check for leaks.
11. Push the Start button. Green light comes on.
12. Insert an empty dish rack into the load end of the dishwasher.
The pumps and conveyor will run.
13. Allow the dish rack to travel to the unload end of the dishwasher. The final rinse
will run.
14. Allow the rack to exit the dishwasher. The dishwasher should have run for
90 seconds.
15. Place another dish rack in the machine to start another cycle.
16. Open each dishwasher door to make sure the safety switch stops the conveyor.
17. Immediately close the door, the dishwasher should restart.
18. Open the door and leave it open for 5 minutes. The machine should stop.
Push the Start button and the machine should restart when a rack is inserted into
the machine.
19. Push the Stop button when the machine is running and the dishwasher should stop.
20. Push the dishwasher Power Switch OFF. The dishwasher should shut down.
21. Drain the dishwasher and check that floor drains handle the water volume leaving
the dishwasher.
NOTE:
If the drain valve is open when the dishwasher is filling, the machine will
fill for 10 minutes, then the machine will shut-down and the green light
will blink on and off. Flip the dishwasher power switch off and close the
drain valve. Flip the power switch on and fill the machine.