Document 90-00066
Algo Communication Products Ltd
(604) 454-3792
2014-02-20
4500 Beedie St Burnaby BC Canada V5J 5L2
Page 6
www.algosolutions.com
Quick Start
1.
Connect the 8128 Strobe to a 802.3af PoE network using the RJ45
jack in the back recess of the housing.
2.
Allow the 8128 Strobe time to boot, about 30 seconds. During boot
up the Strobe will turn on each LED individually as a test and then all
on at low intensity until booting is completed.
3.
If there is no DHCP server found the 8128 Strobe will default to the
static IP address
192.168.1.111
. Most often however the 8128
Strobe will be assigned an IP address. To determine the IP address
for the 8128 Strobe download the Algo locator tool to find Algo
devices on your network:
4.
Access the 8128 Strobe web page by entering the IP address into a
browser and login using algo as the default password.
5.
Enter the IP address for the SIP server into the SIP Domain field
under the BASIC SETTINGS - SIP tab.
6.
Enter the SIP extension and password information.
7.
Test by dialing the SIP extension for the Strobe . The Strobe should
flash in response to ring (the 8128 Strobe will not answer a ring
event).
Installation & Mounting
The 8128 Strobe can be wall or ceiling mounted. Concealed wiring may
enter from the wall into the wiring cavity. Alternatively, surface wiring may
enter through a channel from the bottom edge. The channel is intended for
cabling 0.2" or 5mm in diameter and is intentionally snug to protect against
moisture ingress.
The 8128 Strobe can be mounted in any orientation but both the bracket
and housing identify TOP. This keeps the bracket wiring channel on the
bottom and the RJ45 jack on the top side.
