ALGE-Timing BANG2, Руководство пользователя

Страница: 7 / 16

Manual
Speaker System BANG2
-7-
2.3 Starting
Before switching on, turn the controller MASTER (12) for total volume to MIN, then turn on the
box with switch POWER (17). The switch glows during operation. In case it is blinking during
operation with batteries, they are nearly empty and should be charged.
In order to prevent damage to the batteries by total discharge, a discharge protection executes
in time an automatic deactivation of the device. Due to the self-discharge, the batteries can
also be discharged when the device is not in use for a longer period of time. Therefore, make
sure to observe the note in chapter power supply.
2.4 Connections for Timing
The BANG2 can be integrated into the starting system with various devices of
ALGE-TIMING
.
Starting devices (connection by cable):
•
electronic starting device e-Start
•
Start Unit SU2
•
Start Unit SU3
•
start microphone SM8 with speech amplifier SV4/SM and headset HS3-2
•
push button 023-02 or 023-10
•
photocell PR1a
False start devices (connection by cable):
•
electronic starting device e-Start W
•
radio push button WTN-PB
•
WTN
•
radio photocell PR1aW
The starting signal is always triggered with a C0 pulse.
Triggering a further C0 pulse within 5 seconds after starting pulse initiates the set false start
signal.
A further pulse on the set false start channel within these 5 seconds also initiates the set false
start signal.
Note: Every false start obligatory requires a start beforehand. This prevents accidentally trig-
gering a false start before the starting signal.
Attention:
All devices of the WTN series (e.g. BANG2, e-Start W, WTN-PB, WTN) must be set to the
same team!