Alfresco VERSAPOWER, Руководство пользователя

Страница: 8 / 20

8
L.P. TANK REQUIREMENTS:
Use only a standard 20 Lb. (5 Gal.) propane gas cylinder (18-1/4” H x 12-1/4” Ø). The tank must be in-
stalled in the upright position. Do not use a dented or rusty LP tank as it may be hazardous and should
be checked by your LP supplier. Never use a cylinder with a damaged valve.
The LP gas cylinder must be constructed and marked in accordance with the specifications for LP gas
cylinders of the U.S. Department of Transportation (DOT). The cylinder must be provided with a shut off
valve terminating in an LP gas supply cylinder valve outlet specified, as applicable, for connection type
QCC1 in the standard for compressed gas cylinder valve outlet and inlet connections ANSI/CGA-V-I.
LP GAS CONNECTION:
Your ALFRESCO™ VERSAPOWER™ Cooking System for use with LP gas comes equipped with its
own regulator, which MUST NOT be removed. There is also a secondary high capacity, hose/regulator
assembly for connection to a standard 20 Lb. LP cylinder. The LP gas pressure regulator and hose sup-
plied with this unit must be used without alteration.
If this assembly needs to be replaced use only the type specified by ALFRESCO™ for this appliance.
The VERSAPOWER™ Cooking System requires a 90,000 BTU minimum regulator / hose assembly.
To connect the regulator / hose assembly follow the next steps:
1. Locate the regulator and gas connection point in the
rear left side of your unit.
2. Attach a 1/2” FPT x 1/2” MPT (male-to-female) elbow to
the regulator ( see figure # 2 ).
3. Fasten the hose connection to a 1/2” MPT x 3/8” COMP
(compression flare fitting) connected to the elbow.
( see figure # 2 ).
WARNING
ENSURE THAT THE GAS
SUPPLY HOSE DOES
NOT COME IN CONTACT
WITH THE UNIT’S BODY
1/2” FPT X 3/8” COMP
BRASS FITTING
CONVERTIBLE GAS PRESSURE
REGULATOR
LP REGULATOR AND
HOSE ASSEMBLY
(PRESET TO 10” WC)
1/2” FPT X 1/2” MPT
90° ELBOW
TYPICAL LP GAS TANK
Figure # 2