Alfred DB1-B Series, Инструкция по программированию

Страница: 4 / 7

Factory Default Settings
Lock Operation
-Change Default Master PIN code
1. Touch the screen with your hand to activate.
2. Enter “*” twice and the 8-digit default Master PIN Code(12345678) followed by “#”.
Succeed: Beeper sounds “di-di”, green indicator flashes.
Failed: Beeper sounds “di-di-di”, red indicator flashes.
3. Enter “1+ new Master PIN code + #”, lock response: Refer to response upper.
4. Enter “new Master PIN code + #”, lock response: Refer to response upper.
-Add Up User PIN Codes
User PIN codes can be programmed through the Master PIN Code or APP.
1. Touch the screen with your hand to activate.
2. Enter “*” twice and the Master PIN Code followed by “#”.Lock Response:
Succeed: Beeper sounds “di-di”, green indicator flashes.
Failed: Beeper sounds “di-di-di”, red indicator flashes.
3. Enter “2 + User Number(00-19)” followed by “#”. Lock Response: Refer to response upper.
4. Enter User PIN Code(4-10 digits) followed by “#”. Lock Response: Refer to response upper.
5. Do step 4 again.
When registering User PIN Codes, the code must be entered within 10 seconds or time expires. No matter setting succeed or failed, the process
will complete and exit Master Mode.
-Delete User PIN Code
User PIN codes can be programmed through the Master PIN Code or APP.
1. Touch the screen with your hand to activate.
2. Enter “*” twice and the Master PIN Code followed by “#”. Lock Response:
Succeed: Beeper sounds “di-di”, green indicator flashes.
Failed: Beeper sounds “di-di-di”, red indicator flashes.
3. Enter “3+User Number(00-19)” and followed by “#”. Lock Response: Refer to lock response upper.
4. To continue deleting users, do previous steps from 1-3 again.
When deleting User PIN Codes, the User Number must be entered within 10 seconds or time expires.
No matter setting succeed or failed, the process will complete and exit Master Mode.
Deleting all User PIN codes could be done only by resetting to factory default settings.
-Auto Re-lock enable/disable
Auto Re-lock feature can be programmed through the Master PIN Code or Alfred APP.
1. Touch the screen with your hand to activate.
2. Enter “*” twice and the Master PIN Code followed by “#”.
3. Enter “41+ #” to enable Auto Re-lock.
Enter “42+ #” to disable Auto Re-lock.(Default setting)
Wrong Code Entry Limit:
After a specified number of unsuccessful attempts at entering a valid PIN code the lock will shut down and not allow operation. Wrong code entry limit is
10 times.
Reboot button:
When the system crash down, the lock could be restart by pressing Reboot button on outside escutcheon.
Reset button:
After reset operation, the lock will be restored to factory default settings, all user credentials will be deleted. Refer to reset guide.
Definitions
Master PIN Code
Auto Re-lock
Beeper
Wrong Code Entry Limit
Shutdown Time
12345678
Disabled
Enabled
10 times
5 mins
Lock Operation
Before changing default Master PIN code, all other setting menu are disabled.
You have to change Master PIN code first, then do other lock settings.
Bluetooth
Disabled(Energy saving)
Settings Factory Defaults
5/9
4/9