alfen 904461001, Руководство пользователя

Страница: 16 / 24

16
Eve model 2017 (2.0) manual | Version 1.0 | July 2017
ENGLISH
3. INSTALLING AND CONNECTING
Image 2: Fixing the cable cover
Preparing the charging station
Do not remove the transparent foil from the casing during
installation. This helps to prevent damage such as scratches
on the display. Before installation, the white cover must be
removed from the charging station. This is done as follows:
The front cover is firmly attached to the charging station
and is secured with two screws at the top and bottom.
1. lace the device on its back, preferably on a soft under
ground such as the packaging of the Eve.
2. Loosen the screws on the bottom with an Allen key.
3. Use a Torx m5 (T25) screwdriver to loosen the two
screws on the side of the backside of the casing (ref.
image 3).
4. Save these screws somewhere safe, they are required
later.
5. Carefully lift the white cover, starting at the bottom in
an upwards direction.
6. Take the entire white part of the unit and put it at a
safe location where it cannot be scratched or dama
ged otherwise; for instance in the packaging of the
Eve. Be particularly careful with the display screen.
Image 3: Location of Torx T25 bolts to release, adjust and fasten
the enclosure
Installing the charging station
1. Place the casing onto the already installed mounting
block, in a vertical downward movement.
2. Attach the casing on the top side with two screws
(max. diameter 8mm) at the right position (ref. image
4).
Image 4: Wall mounting
3.4 Electrical installation
WARNING
Carefully read and follow all safety instructions in this
manual!
DANGER!
The electric system must be completely disconnected from
every power supply prior to carrying out installation and
maintenance work!
1. Pull the power cable through the cable inlet,
(
5
on page 2).
2. Pull the power cable at least 15 cm into the housing
from the ground or wall.
3. Secure the power cable in the cable inlet by
tightening it so that the power cable cannot be
removed. The cable gland also functions as a strain
relief.
4. The subframe with the type 2 charging sockets must
be detached, refer to images 5 and 6. The subframe is
equipped with a clicking mechanism on all four
connection points. Detaching the subframe is best
done by first detaching one side (left or right)
followed by the other side.