ALFAtron ALF-25X-4KCAM, Руководство пользователя

Страница: 22 / 45

ALF-25X-4KCAM
19
4. Network Configuration
4.1 Network Connection
Direct Connection
：
Direct connections via “cross-over” network cable
Connection to LAN
：
Connections to LAN via patch cable to LAN wall jack or LAN switch

Please do not put the power and network cable in places where can be easily touched to
prevent video quality lowered by unstable signal transmission due to poor contact of cables.
The computer must have the network segment where the camera IP address belongs to. The device
will not be accessible if without the segment. I.E. The camera default IP address is 192.168.5.163,
then segment 5 must be added in the computer.
Specific steps are as below:
Firstly open the window of Local Area Connection Properties on computer, select the “Internet
protocol version 4(TCP/IPv4)” as shown by picture on the left. Double click or click the property
“Internet” protocol version 4 (TCP/IPv4)to enter into the Internet Protocol Version 4(TCP/IPv4)
Properties window, select “Advanced” to enter into the Advanced TCP/IP Setting and add IP and
subnet mask in the IP browser as picture shown below. Click the “Confirm” to finish the adding of
IP segment. User can add the corresponding network segment according to the revised IP address
of the camera.

The IP address to be added cannot be same with that of other computers or devices.
The existence of this IP address needs to be verified before adding.
Click the “Start” and select “Operation” to input cmd as picture below to verify if the network segment
has been successfully added.