**Prior to this configuration, go to Menu 23 and choose
either metric (cm) or Imperial (inches) measurements.
Press the
right button
to start speed configuration and
press again the
right button
to choose if you are using a
sensor or not.
Press the
left button
to set and pass to the next menu.
If you have chosen without sensor, pressing the
right but-
ton
will allow you to enter the tire’s size (wheel circumfer-
ence) wait for the
arrows up
and
down
,and set with
left
button
.Next set the number of teeth on small sprocket
using
right button
and with
arrows up
and
down
, set
again with
left button
.
Finally, using the
right button
set the gear size of the rear
axle (number of teeth), and
left button
sets & passes to
next menu.
If you are using a speed sensor, you will be using the
"ON"
sensor menu.
Tip: when sensors face magnets, 2 green LEDS from shift
light are on.
Use
right button
to set sensor
"ON"
Press the
left button
to enable entering of data
Press the
right button
to enter the tire size (wheel circum-
ference) (wait
arrows up
or
down
).
Press the
left button
to set and pass to the next menu.
Toll Free:1 (877) 462-7296
10
SPEED
SPEED
SPEED w/SPEED SENSOR
(For Vehicle w/Clutch)
SPEED WITHOUT SENSOR
(For Direct Drive)
www.Alfano-usa.com
