4
Ignite the paper and leave the door half-open, so that the sealing pigtail will not stick to the stove
paint.
The paint completely hardens even after few hours of heating.
During the first hours of operation, due to pain hardening, an unpleasant smell might be created in
the rooms where stoking is performed.
Please, aerate the room well.
When the chopped wood filling is well inflame, open the door and fill the stove firebox with the
required quantity of adequate fuel.
In order to maintain the glass without smoke as long as possible, wood should always be piled so
that the cut surface is not turned towards the glass.
During paint hardening, please do not he paint or do not put anything on the stove, in order to avoid
paint damaging.
The stove firebox is inlaid with chamotte plates. The chamotte plates activate heat, and emit it also
in the firebox thus increasing the combustion temperature.
During stoking of the stove in the transit period, fill the firebox with a smaller quantity of wood.
Open the air regulators more so that the current fuel can burn away faster (with the creating of
flame), thus stabilizing the flue draft.
In order to avoid poor combustion in the firebox, the ash should be more frequently and carefully
shined with intense heat.
4.2. Safety measures while using the stove
Never use water to extinguish fire.
The stove must not be placed on an inflammable pad, that is, the floor must be made of inflammable
material, for example plate of metal sheet, ceramics etc. The pad must cover at least 60cm in front
of the stove and 20 cm from the sides.
The distance to the back wall must be at least 20cm.
Inflammable elements must not be found in the area of emission of the stove.
The unpleasant smell cannot be avoided. It will disappear, but after few hours, when the paint
hardens.
During stove commissioning, the paint is soft. Please do not wipe the stove with a cloth and do not
put anything on it.
Empty the content of the ashtray in some metal or inflammable container intended solely for that
purpose.
The seemingly cooled ash can be very hot even after cooling for some time.
5. Installation of the continuously burning stove
For proper installation of the stove, you should check the draft in the flue, since a good draft is a
condition for proper stove operation.
Check of the draft strength is best and most easily performed by using a candle (see figure 3).
fig.3
slight draft
good draft
very strong draft
