Alfa Network LU-VE Optigo FMS25, Инструкция по эксплуатации, Страница: 11 / 24

31592031EN-01
11
Alfa LU-VE is a trademark registered and owned by LU-VE Group.
Alfa LU-VE reserves the right to change specifications without prior notification.
6.2 Mounting bracket
Use suitable studs when mounting the unit to the
ceiling.
Fix the unit to cold room ceiling by securely
tightening nuts and washers.
FMS25: Ø 6 mm
FMS30: Ø 8 mm
6.3 Technical spaces
Heat exchangers should be positioned such that the following criteria are met:
• Adequate space must be left on the air inlet side of the heat exchanger. The air discharge side
should be free of restrictions. Recirculation of air is to be avoided.
• The heat exchangers should not be connected to ducting on either the air inlet side or discharge
side, unless the heat exchanger has been specifically designed for such an application.
It is important to remember that the total amount of heat to be dissipated depends on receiving
the full design air volume at the design entry air temperature which allows this air to be freely
discharged after passing through the heat exchanger. Any restrictions may impair the performance
of the cooler. If in doubt, please check with Alfa LU-VE.
120 mm
100 mm
FMS25 FMS30