Alfa Laval SMP-BC, Инструкция по эксплуатации

Страница: 10 / 46

3 Installation
Study the instructions carefully and pay special attention to the warnings!
The valve has welding ends as standard but can also be supplied with fittings.
CIP = Cleaning In Place
3.4 General installation
Step 1
- Always read the technical data thoroughly (see 6 Technical data).
- Always release compressed air after use.
- Never touch the clip assembly or the actuator piston rod if the actuator is supplied with compressed air.
CAUTION!
Alfa Laval cannot be held responsible for incorrect installation.
Step 2
Install the valve so that:
-
The actuator is turned to the uppermost point.
- The detecting valve is self-draining.
- The flow is against the closing direction to avoid water hammer.
A = Inlet
Stop valve Change-over valve
A
TD 430-081_1
A
TD 430-093_1
Avoid water hammer!
Step 3
Avoid stressing the valve.
Pay special attention to:
-
Vibrations.
- Thermal expansion of the tubes.
- Excessive welding.
- Overloading of the pipelines.
Risk of damage!
Step 4
Fittings:
Ensure that the connections are tight.
Remember seal rings!
10