14/16
ALFA IN a.s. ©
www.alfain.eu
the encoder
A9
to select the desired JOB number, from which you want to
load your selected parameters, then confirm your choice by short pressing
the encoder
A9
.
HOW TO DELETE SAVED PARAMETERS FROM THE JOB
It is not possible to delete parameters from the JOB, they can be only replaced
by new parameters. To save new parameters, see the chapter HOW TO SAVE
PARAMETERS TO THE JOB above.
9. RESET
The factory reset is performed as follows:
1. By long pressing the encoder
A9
get into the JOBs menu. The display
A10
will show
-S-
.
2. Rotate the encoder
A9
to move to the position
-L-
. By short pressing the
encoder
A9
confirm the position
-L-
.
3. Rotate the encoder
A9
and select the number
1
, which is designed for
factory reset
, then confirm your choice by short pressing the encoder
A9
.
10.
ROUTINE MAINTENANCE & INSPECTION
1. The only routine maintenance required for the PERUN range of machines
is a thorough cleaning and inspection, with the frequency depending on
the usage and the operating environment.
WARNING
2. Disconnect the PERUN from the mains supply voltage before
disassembling.
3. Special maintenance is not necessary for the control unit parts in the
Welder. If these parts are damaged for any reason, replacement is
recommended.
4.
CAUTION
5. Do not blow air into the welder during cleaning. Blowing air into the welder
can cause metal particles to interfere with sensitive electronic components
and cause damage to the welder.
6. To clean the welder, disconnect it from the mains supply voltage then open
the enclosure and use a vacuum cleaner to remove any accumulated dirt
and dust. The welder should also be wiped clean. If necessary, solvents
that are recommended for cleaning electrical apparatus may be used.
7. Troubleshooting and repairing of PERUN welding equipment should only
be carried out only by suitably qualified or competent person.
8. A ‘competent person’ must be a person who has acquired through training,
