19/23
ALFA IN a.s. ©
www.alfain.eu
Set the welding current by setting the welding voltage first and then configure
the wire feed speed to the point, where the burning of the arc is ideal.
Please note that the actual settings for ideal arc may vary slightly depending on
the position of the weld material and voltage fluctuations.
To achieve a good quality of the welds and the optimum setting of the welding
current it is necessary to ensure that the distance of the power nozzle from the
material was about 10 times the diameter of the welding wire (pic. 10)
Picture
10
– Distance from nozzle to material
10. MMA WELDING (COATED ELECTRODE- ELE)
1. Choose ELE method (see
SETTING THE METHOD OF WELDING
)
2. The left display
A10
shows the value of welding current, the right display
A11
shows ELE.
3. The welding current is set by the encoder
A5
.
4. During welding, the display shows measured values of welding current.
5. After welding, on the display will remain measured value (HOLD) for 6 sec.
6. If the MIG/MAG remote torch stays connected, on its display will be shown
ELE. The remote function will not work. Careful, the welding voltage will
be on the torch.
11. ROUTINE MAINTENANCE & INSPECTION
1. The only routine maintenance required for the PEGAS range of machines
is a thorough cleaning and inspection, with the frequency depending on
the usage and the operating environment.
WARNING
Disconnect the PEGAS from the mains supply voltage before
disassembling.
2. Special maintenance is not necessary for the control unit parts in the
Welder. If these parts are damaged for any reason, replacement is
recommended.
CAUTION
Do not blow air into the welder during cleaning. Blowing air into the welder