13/19
ALFA IN a.s. ©
www.alfain.eu
electrode (for AC green or golden). The electrode should be sharpened
also corresponding to the AC or DC mode.
13.
Set the welding current by means of Encoder
11
.
14.
Other parameters may be set by means of the encoder
11
.
Illuminate the appropriate LED by means of pressing the encoder
11
, by
means of turning the encoder
11
set the parameter and save it by means
of pressing the encoder
11
. After that a next LED will illuminate and you
may set that parameter the same way.
The set parameter will be
automatically memorised when you move to another parameter of after 3
s. At every turning of the encoder 11 the last selected parameter will be
offered to be changed.
15.
Connect the work clamp to the work piece or at the welding table
and you can start welding.
16.
The following table describes the influence setting the clearance
effect.
Clearance effect
Value -5 to 0
Value +1 to +5
Shape of the current
curve
Penetration
Deep
Shallow
Level of wear of the of
tungsten electrode
Smaller
Bigger
