Alfa IN AXE 250 IN MIG MAN, Инструкция по эксплуатации, Страница: 15 / 24

15/24
ALFA IN a.s. © www.alfain.eu
WELDING MODE 4T – FOUR STROKE
Works for both welding methods MIG/MAG.
Press the button V19 to switch between the modes 2T / 4T . The
two stroke mode is signalized by LED V18 .
1. Tact – press and hold the button the machine will start welding
2. Tact – release the torch button the machine will continue
3. Tact - press the torch button the machine will continue
4. Tact - release the torch button the machine will stop
SECONDARY PARAMETERS MENU
From start the welding machine is set to factory settings (default). For most of
the work it is not appropriate to change the secondary parameters. Secondary
parameters for manual and synergistic methods are identical.
1. Simultaneously pressing V19 and V5 encoder enters the menu for
secondary parameters.
2. A5 encoder selects a parameter (ISP, PRG, PoG, brn), V19 encoder sets
the desired value.
3. Press the encoder V5 to confirm the change.
4. Press any button to exit the menu without saving changes.
Symbol Meaning Range (Default)
ISP (Initial speed) Approaching speed 10 - 100 % (30 %).
PrG (Pre gas time) Pre gas 0 - 20 s (0,1 sec).
PoG (Post gas time) Post gas 0 - 20 s (0,5 sec).
brn (Burn back) Burn back 0 - 75 ms (35 ms)
CAL (Calibration menu) Calibration menu x.xx (version sw PCB
engine)
The last menu item is CAL – it is used to enter the calibration menu, which is
intended only for authorized service.