World leader in metal detection for anti-shoplifting purposes
900-1003114 Alert HyperGuard Quick pager MP10D (English V1)
Page: 5/9
Date:May 31, 2013
3. ADJUSTMENTS
3.1 Pager receiver programming
Receiver
ON/OFF
ON
: Press
On/set
.
Two beeps and a vibration are indicated (if enabled).
The LED’s shows a running light from left starting with
blue,
yellow
,
green
and
red
Every 10 seconds a short flash in the
green
LED shows that the receiver
is ON
OFF
: Press
On/set
and keep pressed until the LED’s shows a running
light starting with
red
to
blue
.
One beep and a vibration are indicated (if enabled).
Manuel alarm reset
The receiver shows an alarm by a flashing LED, a sound and a vibration.
Press and hold
OK
2 seconds to reset the alarm.
Automatic alarm reset
Connect the receiver to the adaptor.
Press
OK
and
Menu
at the same time for 3 seconds
Two short beeps are heard and vibrator vibrates twice =
Automatic reset ON.
Info in display: MSG TO ON
One short beep is heard and vibrator vibrate once =
Automatic reset OFF.
Info in display: MSG TO OFF
Repeat of the latest alarms
The latest ten alarms are stored in the memory in the receiver.
Press once on
Menu
shows the latest alarm.
Press twice on
Menu
shows the second latest alarm. And so on.
Vibrator and beeper
ON/OFF
Connect the receiver to the adaptor.
Press
OK
, the vibrator vibrates once = Vibrator OFF.
In display: VIBR. OFF
Press once again
OK
, the vibrator vibrates twice = Vibrator ON.
In display: VIBR. ON
Press
Menu
, the buzzer beeps once = Buzzer OFF
Info in display: BUZZER OFF
Press once again
Menu
, the buzzer beeps twice = Buzzer ON
Info in display: BUZZER ON
Coding of extra receiver
There are no limit in numbers of receivers that can receive info from one
Transmitter. They only have to be coded to the transmitter.
Make sure that the receiver is OFF.
Press
On/set
and immediately (while LED’s shows a running light) after
press
OK
until the
blue
and the
red
LED’s are flashing.
Within 5 seconds press
TEST
on transmitter.
(
Blue
led next to TEST bottom flashes)
Info in display: ASSIGN HOME ID
If the coding is OK two short beeps are heard.
If the coding fails one short beep is heard.
