ALERT HOUSE MinkPolice, Руководство пользователя

Страница: 18 / 36

MinkPolice User Manual
EN - 4
communication, wait for another 3 minutes until the device has
installed the new parameters, and then the device is ready for use.
- While setting up the tilt sensor, place the magnet on the red
marker in order to disable tilt sensing. When the trap is in neutral
position, remove the magnet and wait for two beeps. The neutral
position is now set, and the device will monitor the chosen angle
from this position. The device must be tilted at the threshold
angle for at least one second in order to detect the tilting.
- After the trap was tilted, bring it back into the neutral position.
Place the magnet on the red marker until you hear the two beeps,
and then remove the magnet again.
- In order to use the module with the magnet sensor again, change
the type of module in your settings
Æ
Trap
Æ
Type of trap to
MinkPolice Alarm. Then reset the device by placing the magnet on
the side of the module on top of the SIM card holder until you
hear a long beep, and then remove the magnet.
If the module gives off three short beeps instead of two long beeps,
it is because the module did not connect to the server. See possible
causes and solutions in the section Troubleshooting in the end of
this manual.
9.4 Set your preferences
On your user profile on www.minkpolice.com, you can configure
time of daily reports, and to whom email and/or SMS reports should
be sent. Read more about this in the section Online user interface
on www.minkpolice.com.
9.5 Mounting the module on a trap
It is recommended to mount the module onto the trap and then
adjust the length of the string that connects the magnet holder to
the trap door.
- For cage traps, mount the module onto the trap using the two
plastic strips. For wooden traps, use screws for mounting the