Aleratec 330107, Руководство пользователя

Страница: 18 / 45

www.aleratec.com 12
Using the USB Duplicator
4. When Compare is complete the display will show the total, and the
number that pass and fail.
Asynchronous Compare
Asynchronous Compare is used only when the source content is the same as
or less than the system buffer (256MB). With the source content read into
the systems buffer you can compare flash drives continuously by taking out
the drive which has finished comparing, and replacing it with another flash
drive. This process is repeated until the comparison job is complete.
1. Load the source flash drive into the USB Duplicator. Use the UP or
DOWN arrow to scroll through the menu until Compare is displayed
on the LCD screen.
2. Press the OK button on the display panel. The USB Duplicator will
start to read the source content into the system’s buffer and immediately
start comparing any loaded target USB flash drives.
3. Load the target flash drives to be compared into the USB Duplicator.
The LCD will display the number of flash drives loaded and comparing.
Note: When compare is in process the Green LED on the front panel
is blinking. Do not take out the drive while it is comparing. When
comparing is finished the Green LED stays on (no blinking). If an error
occurs during the process a Red LED will display.
ESC
OK


USB(58M) 450M
Reading...
ESC
OK


ESC
OK


USB Duplicator
2. Compare
Pass: 0 Working
Fail: 0 3
ESC
OK


ENT


ESC
ENT


ESC
ENT


ESC
ENT


ESC
Total OK: 5 OK: 5 NG: 0
1:03 OK: 5 NG: 0