TROUBLE SHOOTING
Problem
Evaluation
Solution
Table is not running
Need to check the following:
Is the power cable connected to the main power supply
with correct voltage?
Connect plug to main power supply to make sure
the voltage is ok.
Make sure that all plugs are inserted correctly in the
control box and to the columns.
Check all connections.
One or more columns/cables are defective.
Perform a reset and move table up a bit. If a
column will not move upwards after resetting, it is
defective.
Look for visible damages on cables, control box and
columns.
Damaged parts must be exchanged - contact
supplier.
The table operates irregularly or is tilted.
Visual observation.
Perform a reset.
The table stops and can only move downwards. Is the table at its highest position?
When the table has reached the maximum height,
it can only move downwards.
The table could be overloaded.
Remove some of the load and perform again.
The table will only move downwards even though
the frame is not overloaded.
Visual observation.
Perform a reset.
The table always stops at the same position,
before reaching maximum height.
Has the system been programmed to this specific
height?
Perform a reset.
Is the table at its highest position?
When the table has reached the maximum height,
it can only move downwards.
The table could be overloaded.
Remove some of the load and perform again.
Not all columns move when you move the table
downwards.
The column that does not run could be defective or
the cable connection for the column is not working
properly.
Check all connections, then perform a reset. If a
column will not move upwards after resetting, it is
defective.
