Low-Pressure Transfer Pump
SER 9916-A
Alemite LLC
7
Revision (2-10)
3. Install O-Rings (
11
) onto both ends of the Outlet
Body.
4. Screw Bushing (
16
) [with thread sealant] into
the Outlet Body as required
• Tighten the Bushing securely.
Rod and Fluid Piston
5. Install Retaining Ring (
23
) onto Rod (
22
) as
required.
IMPORTANT: Make sure the ground
side of Plate (26) contacts Fluid Pis-
ton (24).
6. Install Fluid Piston (
24
) [segmented side first],
Gasket (
25
), and Plate (
26
) [ground side first]
onto the bottom of the Rod.
7. Install Nut (
27
) that secures the Plate to the Rod.
• Tighten the Nut securely.
• Place an appropriate size punch or other
suitable tool into the hole of the Rod.
CAUTION
Install the Rod assembly into the Body with a
twisting motion. Use care not to damage the
Seals.
8. Install the Rod assembly into the bottom of the
Outlet Body.
• Position the Fluid Piston flush with the bottom
of the Body.
Air Piston
CAUTION
Use care not to switch Washers (6 and 10).
Component damage can occur.
9. Install Washer (
10
) [brass color] , O-Ring (
9
),
and Air Piston (
7
) (observe THIS SIDE UP]
onto the Rod.
10. Install Washer (
6
) [silver color] and Nut (
5
) that
secures the Air Piston to the Rod.
• Tighten the Nut securely.
• Place an appropriate size punch or other
suitable tool into the hole of the Rod.
11. Install Quad-Ring (
8
) onto the Air Piston.
Figure 4
Pump Tube Assembly (w/o Air Motor) - Section View
Refer to
Figure 2
Parts List for Parts Identification