SER 9911-1
High-Pressure Stripped Pump
Revision (4-02)
9
Alemite Corporation
Model Dependent Step
Step for all Models except 9911-1
8. Screw the Piston assembly onto the
Extension until the Pin holes align.
• Secure the Piston to the Extension
with Roll Pin (20).
Step for Model 9911-1 Only
Screw the Piston assembly onto the
Rod until the Pin holes align.
• Secure the Piston to the Rod with
Roll Pin (20).
9. Screw Primer Rod (34) into the Piston
assembly until the Pin holes align.
• Secure the Piston assembly to the
Primer Rod with Roll Pin (25).
10. Install and seat Bearing (26), Seal (27)
[heel end first], and additional Bearing
(26) into the externally threaded end
of Lower Tube (29).
11. Install and seat Gasket (28) into the
internally threaded end of Upper Tube
(18).
IMPORTANT: If a primer is
used with Loctite 222, the
c u r i n g t i m e i s g r e a t l y
reduced.
12. Screw the Lower Tube [with Loctite
222] into the Upper Tube.
• Follow the thread sealant
manufacturer’s recommendations.
• Do not tighten at this time.
13. Install the Rod assembly into the
Upper Tube until it protrudes from the
Lower Tube.
• Use care not to damage the Seal.
14. Install Seal (31) [heel end first] into
Foot Valve (32).
15. Install Stop (30), the Foot Valve
assembly [Seal end first], Gasket (28),
Seat (33) [small diameter end first],
and additional Gasket (28) over the
Primer Rod and into the Lower Tube.
16. Install Primer Disk (35) onto the
Primer Rod.
• Make sure the hole align.
17. Install Roll Pin (36) that secures the
Figure 4
Pump Tube Assembly - Section View
1
Refer to Figure 2-A and 2-B Parts List
for Parts Identification